Below are the requirements for communicating with SenseAnywhere AccessPoints (Receivers):

The AP will need:

• 1 Power Socket;
• 1 Network connection;

The IT requirements are as follows:

• Acquisition of IP by DHCP (preferred);
• Communication to the endpoint a.sa1.nl port 80;
• TCP/IP protocol;
• Doesn’t allow proxy configuration.

As an alternative to assigning an IP via DHCP, which is preferred, it is possible to assign a static IP:

1: Place the PC's IP in the same range (192.168.0.50); .  

2: Connect the RJ45 cable (AP -> PC);

3: Access 192.168.0.50/config.htm; 

4: Assign the desired settings: 

(purely illustrative image)

If you can't access it, you can perform a hard-reset by pressing the button for about 20 seconds and starting the process again. The hard-reset establishes DHCP by default:

It is also possible to reserve IP by MAC Address.

The MAC Address is obtained from the device's Serial Number by adding (00:21) at the beginning and removing the last two digits of the SN.

Example, SN: 5B:01:23:45:67 -> MAC Address: 00:21:5B:01:23:45

These devices do not respond to pings